Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring AP Loopback
Networking Requirements
As shown in Figure 3-86, the AC is connected to the aggregation switch in bypass mode. To test connectivity between the AP and Router, configure AP loopback.
Data Preparation
Table 3-86
| Item | Data |
|---|---|
IP address pool for the AP |
10.23.100.2-10.23.100.254/24 |
Gateway address of the AP |
10.23.100.1/24 |
IP address of the Router |
10.23.101.2/24 |
Configuration Roadmap
The configuration roadmap is as follows:
- Configure wireless services on the AP. For details, see Example for Configuring Layer 2 Tunnel Forwarding in Bypass Mode.
- Configure AP loopback parameters and start the AP loopback test.
Procedure
- Configure a route to the AP on the Router.
- Choose . The AP-Ping page is displayed.
- Configure AP ping parameters. After the configuration is complete, click Start to start the AP loopback test.
- Verify the configuration.
The test result is displayed after the loopback test is complete. The test result "Success count: 4; Failure count: 0" indicates that the network between the AP and Router is reachable.
