Adjusting the Display Base Height (For the TP3206-65 G2 and TP3218-70 G2 Only)

Background

When installing the TP3206-70 G2 and TP3218-70 G2 tri-screen telepresence system, you need to adjust the display base height.

Labels of "70" and "65" are attached to the display support and camera rod on a rack to indicate their installation heights for the 70-inch and 65-inch telepresence systems, respectively.

To install the 70-inch telepresence system, lower the display base as labeled, as shown in Figure 4-3.

Figure 4-3 Adjusting the height of the 70-inch display base

Adjusting the Display Base Height

There are three display bases, which are located on the left rack (A-01), the center rack (A-02), and the right rack (A-03), respectively.

The methods for adjusting these three bases are the same. In the following procedure, the center base is adjusted.

1. Remove the eight M6 x 16 hex socket screws in the left and right sides of the display base, as shown in Figure 4-4.
   Figure 4-4 Removing the screws
   

2. Raise the display base to the middle of the "65" and "70" labels, as shown in Figure 4-5.
   Figure 4-5 Middle holes
   

3. Use the hexagon electric screwdriver to tighten eight screws in the left and right sides, as shown in Figure 4-6.

   The location where each screw is to be installed has three holes. Install the screw into the uppermost hole.

   Figure 4-6 Tightening the screws