Assembling Guide Rails

Background

Two sets of guide rails (one set in the upper part and the other in the lower part) need to be installed on the rack of each 65-inch or 70-inch telepresence system. Each set consists of three guide rails. They are used for installing the rear panel.

Procedure

1. Assemble one set of guide rails (B-01, B-02, and B-03).

   The assembly procedure for the upper set of guide rails is the same as that of the lower set of guide rails. The following procedure uses one of the two sets as an example.

   1. Locate the three guide rails according to the "LEFT", "MID", and "RIGHT" labels on them.
   2. Align and connect the connectors of guide rails B-01, B-02, and B-03. See in Figure 4-1.
   3. Use the hexagon rechargeable electric screwdriver to tighten two M6 x 16 hex socket screws at the connector. See in Figure 4-1.

   When tightening the two screws, tighten the left one first.

   Figure 4-1 Assembling one set of guide rails (B-01, B-02, and B-03)
   

2. Assemble the other set of guide rails (B-01, B-02, and B-03).
3. Place the two sets of guide rails against the wall, as shown in Figure 4-2.
   Figure 4-2 Placing two sets of guide rails