Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Cable Trays
Background
The racks have two cable trays (A-09 and A-10).
- The cable tray labeled "A-09" is installed between the left and center racks.
- The cable tray labeled "A-10" is installed between the right and center racks.
The installation methods for these two cable trays are the same.
Procedure
- Align the dowels at two ends of the cable tray with the location holes of the racks, as shown by
in Figure 6-32.
- Use your hand to tighten the captive screws at two ends, as shown by
in Figure 6-32.
Weak and heavy current cables must be separated. Bind weak current cables inside the cable tray, and bind the heavy current cables outside the cable tray.
in 
in 
