Routing the Rack Cables
Camera Cable Routing
Route camera cables on racks before mounting the displays.
For details about how to route camera cables, see Routing Camera Cables.
Display Cable Routing
Before mounting the displays, connect the cables to the ports of the displays.
Two cables need to be connected for each display. They are the video cable and the control cable. See Figure 9-10.
Power cable connecting the display to telepresence room outlets. |
|
Video cable connecting the display to the codec. |
Audio Cable Routing
Figure 9-11 shows routes of the rack side audio cable.
Audio cable delivered with the speaker system and connecting the main speaker to other speakers. |
|
Speaker audio cable parts blocked by the displays. |
|
Audio cable connecting the main speaker to the codec. NOTE:
Route the cable from the inner side of the center rack. |
|
Audio cable used to connect the codec to the multi-functional conference table devices, such as the multi-functional outlets and the microphones, and routed through the center ground wiring groove. |
Network and Control Cable Routing
Figure 9-12 shows the routes of the network and control cables of rack devices other than those of the displays.
Network cable connecting the network switch to the telepresence room network ports. |
|
Network cable connecting the network switch to the codec, the telepresence host, and the wireless router. |
|
Network cable connecting the network switch to the multi-functional conference table devices, such as the multi-functional outlets and the tabletop displays, and routed through the center ground wiring groove. |
|
Control cable connecting the telepresence host to the relay. |
Video Cable Routing
Figure 9-13 shows the routes of the video cable between the codec and the multi-functional conference table devices, such as the multi-functional outlets and the left tabletop display.
Video cable connecting the codec to the multi-functional conference table devices, such as the multi-functional outlets and the left tabletop display, and routed through the center ground wiring groove. |
Power Cable Routing
Figure 9-14 shows the routes of the power cable of the rack devices other than that of the displays and the camera.
Power cables connecting the 1-outlet PDU, codec, network switch, and telepresence host to the relay, and to the telepresence room outlets. |
|
Two power cables for the two 6-outlet PDUs under the multi-functional conference table and connected to the telepresence room outlets through the racks. |
|
Power cable delivered with the main speaker, connected to the 1-outlet PDU on the rack sides, and blocked by the main speaker. NOTE:
Route this power cable from the speaker side that is near the rear panel to the 1-outlet PDU. |
Power Cable Routing
Figure 9-15 shows the routes of the ground cable.
Ground cable of the codec, camera, network switch, and the telepresence host and connected to the ground bar. |
|
Camera ground cable parts blocked by the displays. |
|
Ground bar connected to the ground post. |
