Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Center Ground Wiring Groove and the Table Leg Locating Piece
Procedure
- Install the center ground wiring groove (D-01).
- Align the three location holes of the center ground wiring groove with the three dowels on the rack, as shown in Figure 7-1.
The location holes are highlighted by red circles.
- Tighten two M6 x 16 hex socket screws to secure the center ground wiring groove, as shown in Figure 7-1.
- Align the three location holes of the center ground wiring groove with the three dowels on the rack, as shown in Figure 7-1.
- Install the table leg locating piece (D-02).
- Align the two location holes of the table leg locating piece with the two dowels on the center ground wiring groove, as shown in Figure 7-2.
The location holes are highlighted by red circles.
- Tighten four M6 x 16 hex socket screws to secure the table leg locating piece, as shown in Figure 7-2.
- Align the two location holes of the table leg locating piece with the two dowels on the center ground wiring groove, as shown in Figure 7-2.
