Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
"1DAF vrd PSU firmware needs to be upgraded" Is Reported When npu-smi Is Used to Query the MCU Health Status
- Run the npu-smi info -t health -i NPU ID -c 1 command to query the MCU health status. The following command output is displayed.
- Wait for 10s after the system is powered off and then power on the system.
- Query the MCU health status again.
- If the alarm is cleared, the problem has been solved.
- If the alarm still exists, contact Huawei technical support.
