Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Certificate Replacement
- Configure the environment by referring to Environment Preparation.
- Log in to the server installed with Toolkit as the running user..
In the following content, the HwHiAiUser is used as the running user of the Toolkit component. If another user is specified during Toolkit installation, replace HwHiAiUser with the specified user.
- Run the following command to check the date information on the host. If the date information is correctly displayed, the certificates have been successfully replaced.
adc --host xx.xx.xx.xx:22118 --hostcmd dateReplace xx.xx.xx.xx with the actual IP address of the host.
Pay attention to the following:- In the Ascend EP scenario, ADA is deployed on the host, which is also the host.
- In the Ascend RC scenario, ADA is deployed on the developer board, and the operating environment refers to the developer board. In addition, you can run the adc command on the developer board without logging in to the server where Toolkit is installed.
