Figure 2-2 shows the network ports of the Atlas 500 AI edge station.
Figure 2-2 Atlas 500 AI edge station network ports![]()
Table 2-1 Atlas 500 AI edge station network portsPhysical Network Port
|
Description
|
ETH0, ETH1
|
Both the two network ports can be used as management and service network ports.
The management network port is used to:
- Log in to the Atlas IES WebUI.
- Check the Atlas 500 AI edge station.
- Change the initial user name and password for the IES.
- Change the initial IP address of the IES.
- Set the system time.
- (Optional) Create a drive partition.
- Upgrade the firmware.
The service network port is used to:
- Install the CANN software.
|