Upgrading the HA Using FusionDirector

Prerequisites

• You have purchased FusionDirector.
• You have logged in to the FusionDirector WebUI.
• There is no minor, major, or critical alarm generated on the FusionDirector.
• Edge devices and servers have been managed by FusionDirector.

Data Preparation

Data preparation is not required for this operation.

Software Preparation

You have downloaded the upgrade package. For details, see Obtaining the Upgrade Software Package.

Upgrade Procedure

1. Upload the software package of the target version.
   1. Enter https://FusionDirector IP address in the address box of the browser and press Enter. The FusionDirector login page is displayed.
   2. Enter the user name and password to log in to FusionDirector.
   3. On the menu bar, choose Menu > Configuration > Configuration Deployment > Software Deployment > Software Package Repository.
   4. Click Upload Software Package.
   5. Upload the software package and digital signature file obtained in Obtaining the Upgrade Software Package.

      The software package must be in .zip format, the digital signature file must be in .asc format, and a single file must be less than 4 GB.

   6. Click OK.

2. Create a software installation schedule.
   1. Choose Menu > Configuration > Configuration Deployment > Software Deployment > Schedule Management.
   2. Click Create Schedule.
   3. Configure basic information and select the target device by referring to Table 5-1.
      Table 5-1 Parameter description

      Parameter	Description	Value
      Name	Name of the software installation schedule.	The value can contain 1 to 32 characters, allowing only letters, digits, hyphens (-), underscores (_), and dots (.).
      Description	Supplementary information about the software installation schedule.	-
      Type	Select Install.	-
      Enabled	If this option enabled, the installation starts immediately after the schedule is created. If this option is disabled, the installation starts only after you click Enabled in the Operation column of the schedule list.	-
      Target Device	Click Select Device, and select the devices to be upgraded from the device list.	-

   4. Click Next.
   5. Click Select Software Package and select the target software package from the software package list.
   6. Click Next. A progress bar is displayed, showing the creation progress of the check report. After the analysis is complete, the Check page is displayed.

      Check the device and software information. By default, devices whose versions are earlier than the target versions are selected. You can customize the installation scope by using the Advanced Search function.

   7. Click Next and configure the installation policy by referring to Table 5-2.
      Table 5-2 Parameter description

      Parameter	Description
      Effective Policy	Effective mode after the software is installed. The options are as follows: Take effect later: You need to manually make software take effect after it is installed. For details, see 3. Take Effect Immediately: The software takes effect immediately after installation. If services depend on the software, services may be affected during this process.
      Software Order	Adjust the software installation and uninstallation order based on service requirements. NOTE: You can click Up, Down, Top, or Bottom in the Operation column to change the order.
      Device Batch Policy	Configure the software deployment queue based on service scenarios. Select Enabled. Click in the deployment queue to add devices.

   8. Click OK to start the installation schedule.

      You can view the installation status on the schedule management page.

3. After the installation is complete, manually make the software take effect on the edge device.
   1. Choose Menu > Configuration > Configuration Deployment > Software Deployment > Device Software Version Information.
   2. Select one or more edge devices, click Take Effect, select the software to take effect, adjust the order in which the software takes effect based on services, and click OK.