Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing Structural System Components
Replacing a Cabinet Electronic Clasp Lock
Prerequisites
- Tool: Phillips screwdriver
- Material: A spare cabinet electronic clasp lock is available and functional.
Procedure
- Open the front or rear door of the cabinet.
- Remove the signal cables from the cabinet electronic clasp lock.
- Remove the cabinet electronic clasp lock bolts using a Phillips screwdriver.Figure 6-1 Removing a cabinet electronic clasp lock
- Install the new cabinet electronic clasp lock at the front or rear door of a cabinet.
- Before removing a cabinet electronic clasp lock, remember the DIP switch settings on the cabinet electronic clasp lock. Ensure that the DIP switch settings on the new cabinet electronic clasp lock are the same as those on the old cabinet electronic clasp lock.
- The mounting holes for the new cabinet electronic clasp lock are slotted holes. If the door cannot be properly closed after installation, adjust the lock height based on site requirements.
- Reconnect the cables to the cabinet electronic clasp lock.
Replacing a Gas Spring
Replacing a PDU2000
Prerequisites
- Tools: Phillips screwdriver, step ladder
- Material: A spare PDU2000 of the same model is available and functional.
Procedure
- Open the rear door of the cabinet.
- Switch off the output circuit breaker of the power distribution subrack for the PDU2000. Disconnect the power cables and signal cables from the PDU2000 terminal block.
- Remove the bolts that secure the PDU2000 using a Phillips screwdriver.
- Secure the new PDU2000 to the rear door of the cabinet.
- Reconnect the power cables or signal cables to the PDU2000, and switch on the circuit breaker of the power distribution subrack.