Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Management System Cable Connection
Connecting VCN Cables
Procedure
- Connect one end of the ground cable to the ground terminal on the device and the other end to the ground point on the cabinet. A Phillips screwdriver and M4 screws are required. The ground cable is a yellow-and-green cable of 16–18 AWG.
The customer needs to prepare the ground cable.
- Connect one end of the network cable to any GE network port on the VCN.Figure 4-62 Ports on the VCN
(1) Ground terminal
(2) GE1 port
(3) GE2 port
(4) Power button
(5) Power port
- Connect one end of the power cable to the input power port on the power module and the other end to the PDU2000 in the cabinet.
After connecting the power cable, turn on the power switch on the panel to start the device.
