Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Removing the Aisle Containment
Context
If the site elevator is too small to transport a cabinet, remove the aisle containment from the cabinet. Reassemble them after transporting them to the installation position. Then perform subsequent operations.![]()
The cabinet front door is made of glass. Pay attention to the following during transportation:
- Move the cabinet with caution.
- Ensure that the glass door does not collide with sharp objects.
- Place the glass door stably and reliably.
Procedure
- Open the front and rear doors of the cabinet.
- (Optional) Cut off the cable tie on the PAD cable in the cabinet, and pull the cable into the cabinet through the front door.
Record the PAD cable route because you need to bind the PAD cable along the original route in subsequent installation.
Figure 4-4 Removing the PAD cable - Loosen the gas spring nuts using an adjustable wrench and remove the gas springs.Figure 4-5 Removing the gas springs
Remove the gas springs only when the door is open.
- Disconnect the cabinet ground cable.
- Lift the cabinet doors off the hinges. Remove the front and rear doors.
- The cabinet front door is heavy. Arrange at least two persons to carry the door.
- Before removing a cabinet door, disconnect the ground cable between the cabinet door and the cabinet.
Figure 4-6 Removing the cabinet doors - Remove the top plate from the cabinet using a Phillips screwdriver.Figure 4-7 Removing the top plate
- Remove the screws securing the aisle containment to the cabinet using a Phillips screwdriver, and remove the aisle containment from the cabinet.Figure 4-8 Removing an aisle containment
- Move the removed glass doors, gas springs, top plate, aisle containment, and cabinet to the specified installation position using an elevator.
- Assemble the removed components with the cabinets by referring to 7 to 2.
