Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Performing a Master/Standby Switchover in a Stack
Context
You can manually trigger a master/standby switchover in a stack if the current roles of member switches do not meet your requirement. For example, you can perform a master/standby switchover to change the roles after a restart or restore the original roles after an upgrade.
Before performing a master/standby switchover, ensure that the master switch has two MPUs.
Procedure
- (Optional) Run the display switchover state command to check whether the stack meets switchover requirements.
You can perform a switchover only if the Switchover State field is Ready.
- Run the system-view command to enter the system view.
- Run the slave switchover enable command to enable the master/standby switchover function.
By default, the master/standby switchover function is enabled.
- Run the slave switchover command to perform a master/standby switchover.