Verifying the Installation

1

Labels on the cabinet are clear and properly pasted.

-

2

Screws for securing the cabinet are properly installed.

-

3

Rotate the exhaust valve bonnets on the top of the air/liquid heat exchanger clockwise until they cannot be rotated to ensure that the bonnets are tightened after the first use.

-

4

The branch hose is not excessively bent or dented, and the end connector is free from defects such as sharp bends.

-

5

Branch valves of the liquid-cooled cabinet are open.

-

6

The entire liquid cooling loop has no leakage or condensation after water is supplied.

-

7

Paint on the cabinet is not scraped or the surface is not stained. If not, apply paint or clean up the stains.

-

8

The instructions and accessories delivered with the equipment are intact.

-

1

Cables are properly routed in the cabinet, complying with Huawei's cable layout specification.

-

2

Power cables and protection ground (PGND) cables are properly connected.

-

3

PGND cables and power cables are in good condition without any splice.

-

4

Power cables, PGND cables, and signal cables are independently bundled. The pitches between power cables and signal cables as well as between PGND cables and signal cables meet the requirements.

-

5

Cables are not routed on the dissipation holes of devices.

-

6

Cables are bundled in uniform spacing with appropriate tightness.

-

7

The bending radius at the corner meets the specifications.

-

8

The installed cables do not block the indicators or hinder replacement of components.

-

9

Unused optical cable connectors are covered by protective caps. Unused optical modules are covered by dust covers.

-