When we install SYNLOCK Centralized Monitoring System V3.15 we can't find NTP Manager,Data Statistic and Query time error in Performance Management as shown in attached diagram Before Enabling.While their uses are as follows
NTP Manager is mainly used to configure the Time source,Client settings,time zone settings for NTP Network.
Data Statistic is used to take Alarm Statistics,Performance Statistics,Transmission Fault Statistics,Communication Status Statistics.
Query time error shows the graph of time error between server and client time in performance management.
To enable these functions we can proceed as follows.
1.Close the SYNLOCK Centralized Monitoring System.
2.When we intall SYNLOCK Centralized Monitoring System then by default it is intalled in C --->Program Files--->Huawei folder.Then you got to SynLock --->Data folder.Here yo will find the SynLock.ini file.
3.Open the file SynLock.ini and make.
Stalk Num= 10
Also shown in attached diagrams Stalk Num and Leaf Num.
Stalk Num will enable the NTP Manager and Data Statistic.While Leaf Num will enable Query time error.
4. Start the SYNLOCK Centralized Monitoring System and you will find the parameters of NTP Manager,Data Statistic and Query time error in Performance Management as shown in attached diagram After Enabling.
NTP Manager and Query time error are required only we want to use NTP.If we are not using NTP then these are not necessary parameters and therefore these are not enabled by default.
When you install SYNLOCK Centralized Monitoring System you can enable NTP Manager,Data Statistic and Query time error in Performance Management using above procedure.