There is an Ethernet port in the 62COA Equipment. We can use this port to do software upgrade equipment. Isn't to management. We can manage the equipment through RS232 serial interface.
In order to use ethernet port you must configure the following IP address:
62COA IP address: 10.108.5.bid
Computer IP address: 10.108.5.xx
In order to perform upgrade software in the 62COA equipment, we can use ethernet port or RS232 serial interface. If you use serial interface you will take about 100 minutes. Therefore we recommend you to use the ethernet port to load the board software in the BIOS mode, which will take shorter than 2 minutes by using the UDP_Tools for loading.
We must create a procedure 62COA software upgrade using 62COA's ethernet port.