No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Knowledge Base

FAQ- Is it possible to configure the apparent bandwidth on AR router like command bandwidth of cisco

Publication Date:  2012-07-27  |   Views:  6  |   Downloads:  0  |   Author:  SU1001432938  |   Document ID:  EKB0000460922

Contents

Issue Description

Q:
Is it possible to configure the apparent bandwidth on AR router like command bandwidth of cisco?

Alarm Information

Null

Handling Process

A:
1. "bandwidth"  command of cisco, can be used on all interface, in cisco manual,  "The bandwidth command sets an informational parameter to communicate only the current bandwidth to the higher-level protocols; you cannot adjust the actual bandwidth of an interface using this command."----this means this command can not change interface bandwidth, just inform up layer protocol use this parameter as interface bandwidth.
2."baudrate" of AR just use for SYN serial interface, to set physiacl speed of SYN serial interface. virtualbaudrate is similar as baudrate, can be use on SYN and ASYN serial interface, but need configure DTE same as DCE side. These command does not similar as cisco's "bandwidth"
3. correspond to cisco "bandwidth" command includes :
qos max-bandwith??inform QOS module bandwidth of interface, use to calculation of CBQ. detail info in chapter qos. 
load-bandwidth??use to configure bandwidth of load balance.
4. in addition, if user want control QOS, we canuse "qos max-bandwidth " ; if want use load banlance, we can use "load-bandwidth", if want limite speed, we "lr" and "gts" can be used.

Root Cause

Null

Suggestions

Null