Board EGSH can be configured with electrical or optical ports (ports 6 and 8). LASER MODULE MISMATCH ALARM will appear after insert new electrical module.
Check port type in Function tree --> Configuration --> Ethernet configuration Management -->Ethernet interface --> (External port - Basic attributes) --> Physical type.
Change port type by using next commands in Navigator:
:cfg-replace-port:20,ip6,sdh-eport,ge --> 20 is board Id, ip6 is port 6. you can change these parameters for your case.
After run previous command, please check if change has been done successful with next command.
Ifchange has been done youu will see:
Bid Pid PortType PortLevel
20 ip6 sdh-eport ge
Total records :1
besides that, alarm should dissappear.
After inser electrical module, please check physical port type in NE explorer. Select desired board and click in.
For V100R003C00SPC100, pacth is not available. Please visit support web site to get updated information.