Given the initiator name is updated during the configuration, the updated initiator name is displayed as connected on the iSCSI initiator software after restart. In this condition, a manual connection is required for proper disk detection. To validate the updated initiator, users need to remove targets from Persistent Targets after updating the initiator name and then log in to the T8000. Otherwise, the preupdate initiator name is used after restart. To correct the error, use either of the following methods: Method 1. Log out of the T8000, remove targets from Persistent Targets, update the initiator name, and log in to the T8000. Method 2. Update the initiator name, log out of the T8000. Remove targets from Persistent Targets, and log in to the T8000.