Unable to deploy storage devices as they cannot be started properly.
Product and version information:
The version of the controller software is earlier than 1.03.01.108.T03
Remove the hard disks that failed the capacity detection.
Restart the storage device and wait until it runs properly.
Reinsert the hard disks as mentioned above into their original slots.
By checking the system log of the storage device, strings like "Handle VaultDisk fail" can be found, which indicates registration failures occurred during the registration of coffer disks.
Aug 25 09:29:24 Oceanspace kernel: 1.Add vault disk(Slot id: 3, WWN: 200000188278cf68)
Aug 25 09:29:24 Oceanspace kernel: sda: Unit Not Ready, sense:
Aug 25 09:29:24 Oceanspace kernel: Current : sense key Hardware Error
Aug 25 09:29:24 Oceanspace kernel: Additional sense: Internal target failure
Aug 25 09:29:24 Oceanspace kernel: sda : READ CAPACITY failed.
Aug 25 09:29:24 Oceanspace kernel: Handle VaultDisk fail
By locating the Slot id that is closest to the strings Handle VaultDisk fail, the slot of the coffer disk that is in question can be identified. The coffer disk in slot 3 failed the capacity detection, as shown above.
It is found that the controller enclosure has not yet been registered.
Aug 25 09:29:24 Oceanspace kernel: Find no CtrlFrame
Aug 25 09:29:25 Oceanspace kernel: There is not vault disk,now discard all event
By checking the version of the controller software, the version is found to be earlier than 1.03.01.108.T03.
The alarm thread is unexpectedly activated due to the failure of disk capacity detection, causing the registration of the controller enclosure and coffer disks to fail, and thus unable to deploy the storage device.
This fault can also be removed by upgrading the storage software to 1.03.01.108.T03 or later.