Issue Description
Do the client recovery with BMR recovery CD, configure the host and IP address, and then load the target client disk module.
It occurs the fault:
Handling Process
Input as following figure in BMR recovery command line:
![]()
specify manually:
bmr scsiLoadOrder=mtpscsih:scsi_mod:sg:st:sr_mod:sd_mod,
Make the BMR recovery program use the SCSI loading sequence above and the system will recover.
Root Cause
Both the source client and the target client are both ESX VMs.
The default module is SCSI disk module in VM, and the loading sequence of the SCSI Bus is special. But the default loading sequence in BMR is PCI Bus. So we must specify the SCSI loading sequence in recovery.