Two Eudemon500 make up the VRRP, and enable the VGMP and HRP. The VRRP status is normal of the primary/secondary FW and can switch normally. But there is not HRP_S before the secondary FW host name. Looking over the HRP status, it is in the INITIALIZE status all the time.
Inspect the configuration, without configuring the HRP interface. The interface is the tunnel interface used to backup the FW session table. Without configuring the HRP interface, it is in the INITIALIZE status all the time and the host name of the SLAVE FW can not display normally. The problem is solved after configure the HRP interface.
The reason maybe that:
1. The fault of heartbeat line.
2. The wrong configuration.
This case is caused by the second reason. Without configuring the HRP interface result in the FW host name displaying abnormally.
Consult more about how to inspect the configuration and do more testing.