Issue Description
1、Array reboot steps and Notes;
2、Power on/off sequence of the device.
Handling Process
Step 1 Using the serial interface cable to connect the device controller, and open a terminal tool, baud rate is set to 9600. .
Step 2 Using keyboard send interrupt signal (Ctrl + Break), as shown, press the Esc key (not press the S key) to enter the serial interface.
Step 3 Enter the username:root and password:infiniti to login the shell command line, run reboot to restart the controller.
Note: Do not enter S or Ctrl + S, otherwise can not login shell command line
Step 4 Power on/off sequence:
Power off sequence: control box> extended box
Power on sequence: extended box> control box
Root Cause
Array reboot steps and power on / off sequence of the device must be standardized operation, to avoid unknown cause.
