1.Check the configuration based on the topology. Customer is using static RP and the configuration seems ok. RP information is correct.
2.Check the multicast group 232.X.X.X/24 and find it is SSM multicast group address range.
184.108.40.206/8 is SSM multicast group. By default, SSM multicast address does not need any RP
220.127.116.11-18.104.22.168 Default SSM group addresses that are valid on the entire network.
PIM-SM for SSM:
In the SSM model, user hosts know the exact positions of the multicast sources in advance. When user hosts join multicast groups, they can specify the sources from which they want to receive multicast data. The DR at the group member side then sends Join messages directly to the multicast sources. The Join message is transmitted upstream hop by hop to set up an SPT between the source and group members. The SSM model uses only part of the PIM-SM technology and IGMPv3. There is no need to maintain an RP, set up an RPT, or register a multicast source. As shown in Figure 2, HostA and HostB join a multicast group G. HostA needs to receive multicast data from S1, and HostB needs to receive multicast data from S2. The DRs at the group member side send Join messages to the multicast sources to set up SPTs.
Figure 2 Setting up an SPT in the SSM model
3.And customer configured 232.X.X.X/24 is in SSM multicast address group. Cannot configure static RP for SSM address. There are two solutions :
Please change 232.X.X.X to another no-SSM multicast address like 231.X.X.X
If customer must use it, we can create one SSM policy to deny these IP and then they will not be SSM multicast address.Run:
The PIM view is displayed.
ssm-policy basic-acl-number ///Create basic ACL and deny 232.X.X.X/24