National Research and Education Network
Education Cloud Data Center
Multi-Channel HD Telemedicine Solution
Over The Top/Multi-Tenant Data Center (OTT/MTDC)
Internet Exchange Point (IXP)
Internet Access Provider (IAP)
Design & Simulation
Planning & Analytics
Oil & Gas IoT
HPC & Operations Management
Digital Urban Rail
Retail Cloud Platform
Enterprise Data Center
Enterprise Cloud Communications
Network Management System
Buy from Huawei
If you want to get more information about your project, you can submit your information and we will contact you as soon as possible.
If your company has signed an eDeal contract with Huawei, please buy your required product/solution via the link below.
Buy from resellers
Search for a nearby reseller and get direct contact information.
Become a Partner
Resources and Support
Huawei Authorized Learning Partner
Huawei Authorized Information and Network Academy
when install FusionCompute, Engineer configured VLAN as customer required. However after installation, two CNA cannot ping each other.
1.engineer tried reinstall the CNA without VLAN. then the CNA can ping each other.
2.check the vlan configuration of the switch. we found that port 1 to port 18 were configured into VLAN 2303.
3.check if the VLAN2303 in switch is tagged or untagged.From the picture, we can see, all the port in VLAN2303 was configured untagged.
however, for FusionCompute, VLAN configured in CNA was tagged by default.
the VLAN configured on switch is untagged type while VLAN configured in CNA is tagged by default.that is the root cause CNAs cannot connected in the same network segment.
in this case that VLAN on switch is untagged, no VLAN should be configured in CNA.
So reinstall CNA without VLAN, problem solved.
1.If there is no VLAN in switch, CNA should not configure VLAN.
2.If there is VLAN in switch with type untagged,CNA should not configure VLAN when install it.
3.If there is VLAN in switch with type tagged, CNA should configure VLAN when install it.