No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Eth-Trunk Configurations Cannot Be Deleted After a Stack Consisting of Four CE6855HI Switches Splits

Publication Date:  2019-04-12 Views:  21 Downloads:  0
Issue Description

Eth-Trunk configurations cannot be deleted after a stack consisting of four CE6855HI switches splits and the following message is displayed: Error: The parameter of trunk command is invalid, because the trunk has member interfaces.

[~CE6855-iStack]undo int Eth-Trunk 41

Error: The parameter of trunk command is invalid, because the trunk has member interfaces.

Handling Process

1.       Run the display interface eth-trunk 41 command to check whether any physical member interface exists in Eth-Trunk41.

Eth-Trunk41 current state : DOWN (ifindex: 254)

Line protocol current state : DOWN

Description:

Switch Port, PVID :   1, TPID : 8100(Hex), Hash Arithmetic : profile default, The Maximum Frame Length is 9216

Internet protocol processing : disabled

IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is H-H-H

Current system time: 2018-08-10 10:34:52+08:00

Physical is ETH_TRUNK

  Last 300 seconds input rate 0 bits/sec, 0 packets/sec

  Last 300 seconds output rate 0 bits/sec, 0 packets/sec

    Input: 0 packets,0 bytes

           0 unicast,0 broadcast,0 multicast

           0 errors,0 drops

    Output:0 packets,0 bytes

           0 unicast,0 broadcast,0 multicast

           0 errors,0 drops

    Last 300 seconds input utility rate:  0.00%

    Last 300 seconds output utility rate: 0.00%

----------------------------------------------------------

PortName                      Status              Weight   

----------------------------------------------------------

----------------------------------------------------------

The Number of Ports in Trunk : 0

The Number of Up Ports in Trunk : 0

2.       The problem occurs after the stack splits. It is suspected that the member interfaces of Eth-Trunk41 still reside on the two switches removed from the stack. Run the display current-configuration inactive command to check offline configurations of the switches.

*interface 10GE3/0/1

* eth-trunk 41

#

*interface 10GE4/0/1

* eth-trunk 41 

According to the collected offline configurations, there are offline configurations of Eth-Trunk41. After the offline configurations are deleted using the clear inactive-configuration command, the Eth-Trunk configurations are successfully deleted.
Root Cause

After the stack splits, the switches have offline configurations. As a result, the Eth-Trunk configurations fail to be deleted.

Solution

Run the clear inactive-configuration command to clear the offline configurations.

END