Publication Date: 2019-05-14 | Views: 330 | Downloads: 0 | Document ID: EKB1100015229
How Can I Enable the AR3260 to Restart Without an Active/Standby Switchover?
Generally, restarting the device does not trigger an active/standby switchover. However, if the customer has this requirement, refer to the following operations:
1. For SRUs that support hot swap, remove the slave SRU before restart.
2. Run the power off slot slot ID command to power off the slave SRU. Then restart the device.
3. Run the slave default command to set the slot ID of the slave SRU used for the next startup.
By default, the master SRU is in slot 15, and the slave SRU is in slot 14.
When both the master and slave SRUs on the device are properly installed, you can run the slave default command to set the SRU in a specified slot as the slave SRU used for the next startup.