National Research and Education Network
Education Cloud Data Center
Multi-Channel HD Telemedicine Solution
Over The Top/Multi-Tenant Data Center (OTT/MTDC)
Internet Exchange Point (IXP)
Internet Access Provider (IAP)
Design & Simulation
Planning & Analytics
Oil & Gas IoT
HPC & Operations Management
Digital Urban Rail
Retail Cloud Platform
Enterprise Data Center
Enterprise Cloud Communications
Network Management System
Buy from Huawei
If you want to get more information about your project, you can submit your information and we will contact you as soon as possible.
If your company has signed an eDeal contract with Huawei, please buy your required product/solution via the link below.
Buy from resellers
Search for a nearby reseller and get direct contact information.
Become a Partner
Resources and Support
Huawei Authorized Learning Partner
Huawei Authorized Information and Network Academy
The topology is as following, customer want to establish lacp beteen "client switch1" and "client switch 2", but failed. Meanwhile normal ping from "client switch 1" and "client switch 2" is working.
1.Checked the configuration on CE/PE and found that the basic configuration of VPLS is working, and the ping test between "client switch 1 " and "client switch 2" is working, which means the basic configuration is correct.
2.As we know LACP protocol packets is a kind of BPDU packets, which will be handled by CPU directly and will not transparant by switch. So we need to chance the mac-address of LACP to another one which will not be recognized as BPDU by switch.
A.Set VPLS of Martini and let downlink sub-interface of PE device terminate the assigned VLAN 3023.
B.Enable L2-protocol of LACP on downlink of CE and group MAC 0100-0100-0100.
On switch clientswitch1:
[clientswitch1]l2protocol-tunnel lacp group-mac 0100-0100-0100
[clientswitch1- GigabitEthernet0/0/19] port hybrid pvid vlan 3023
[clientswitch11- GigabitEthernet0/0/19] l2protocol-tunnel lacp enable
On switch clientswitch2:
[clientswitch2]l2protocol-tunnel lacp group-mac 0100-0100-0100
[clientswitch2- GigabitEthernet0/0/8] port hybrid pvid vlan 3023
[clientswitch2- GigabitEthernet0/0/8] l2protocol-tunnel lacp enable
C.Set default VLAN of CE downlink to 3023 and enable smart QINQ which will tag LACP packet with 3023.
D.Switches on both sides create eth-trunk with mode LACP to observe the status of LACP. LACP is setup successfully and its status is kept up.