Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
(Optional) Configuring the DLDP-Compatible Mode

(Optional) Configuring the DLDP-Compatible Mode

Context

This configuration is required if the device works with the following Huawei switches to provide the DLDP function:

  • S8500

  • S7800

  • S6500

  • S5600 series

  • S5100-EI

  • S3900

  • S3500 series

  • S3100 series

DLDP can be configured on Layer 2 and Layer 3 Ethernet interfaces. By default, an Ethernet interface works in Layer 2 mode. Before configuring DLDP on a Layer 3 Ethernet interface, switch the Ethernet interface to Layer 3 mode.

NOTE:

In compatible mode, the default BPDU MAC address carried in a DLDP packet is 010F-E200-0001.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run dldp compatible-mode enable

    The DLDP compatible mode is enabled.

    The DLDP compatible mode must be enabled or disabled on both the two interfaces.

  4. Run dldp compatible-mode local-mac mac-address

    The DLDPDUs sent in the DLDP compatible mode contain MAC addresses.

    After the DLDP compatible mode is enabled on the device, the remote device may discover multiple neighbors, which leads to DLDP flapping. The dldp compatible-mode local-mac command can prevent this problem.

    NOTE:

    At least one bit in the MAC address must be 0, and the MAC address cannot be a multicast MAC address.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125525

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti