Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Creating a VRRP6 Group

Creating a VRRP6 Group

Context

VRRP6 virtualizes multiple devices into one gateway without changing the networking, and uses the virtual gateway's IP address as the default gateway address to implement next-hop gateway backup. After a VRRP6 group is configured, traffic is forwarded through the master. When the master fails, a new master is selected among backups to forward traffic. This ensures device-level reliability.

If load balancing is required in addition to gateway backup, configure two or more VRRP6 groups on an interface in single-gateway load balancing mode or multi-gateway load balancing mode.

Procedure

  1. Create a VRRP6 group working in active/standby mode.
    1. Run system-view

      The system view is displayed.

    2. Run ipv6

      The IPv6 function is enabled.

      By default, a device is disabled from forwarding IPv6 unicast packets.

    3. Run interface interface-type interface-number

      The interface view is displayed.

    4. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    5. Run ipv6 enable

      IPv6 is enabled on the interface.

      By default, the IPv6 function is disabled on an interface.

    6. Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

      An IPv6 address is configured for the interface.

    7. Run vrrp6 vrid virtual-router-id virtual-ip virtual-ipv6-address [ link-local ]

      A VRRP6 group is created, and a virtual IPv6 address is assigned to the VRRP6 group.

      By default, no VRRP6 group is created.

      The first virtual IPv6 address of a VRRP6 group must be a link-local address.

  2. Create VRRP6 groups working in multi-gateway load balancing mode.

    If VRRP6 groups need to work in multi-gateway load balancing mode, repeat the Create a VRRP6 group working in master/backup mode steps to configure multiple VRRP6 groups on the interface and assign different VRIDs to them.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:123861

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti