Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
BFD for MPLS LSPs

BFD for MPLS LSPs

A BFD session established on an LSP can quickly detect faults and provide end-to-end protection for the LSP. When a BFD session is associated with a unidirectional LSP, the reverse link can be an IP Link, an LSP, or a TE tunnel.

Both static and dynamic BFD sessions can monitor the connectivity of MPLS LSPs. Dynamic BFD sessions support only dynamic LSPs. Static BFD sessions support static and dynamic LSPs.

To monitor connectivity of an LSP, the ingress and egress nodes periodically send BFD packets to each other. If the ingress or egress node does not receive BFD packets from the other end within the specified period, BFD considers the LSP as Down and sends an LSP Down message to the LSP management module (LSPM).

Application

Figure 2-11  BFD for MPLS LSPs

In Figure 2-11, when a fault occurs on the link between PE1 and P1, PE1 can detect the fault through its interface connected to P1. When a fault occurs on the link between P1 and PE2, PE1 cannot detect the fault through its interface connected to P1. BFD for dynamic LSPs needs to be configured to quickly detect faults.

A dynamic LSP destined for PE2 is set up on PE1. BFD for dynamic LSPs is enabled and a BFD session is set up. Additionally, policies of Virtual Private Network fast reroute (VPN FRR) are configured on PE1, and the protection path between PE1 and PE3 is specified. When a fault occurs on the link between PE1 and P1 or between P1 and PE2, PE1 fast detects the LSP fault and triggers VPN FRR switching. Traffic is then switched to the PE1 -> PE3 -> CE2 path.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125093

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti