Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Creating a VRRP Group

Creating a VRRP Group

Context

VRRP virtualizes multiple devices into one gateway without changing the networking, and uses the virtual gateway's IP address as the default gateway address to implement next-hop gateway backup. After a VRRP group is configured, traffic is forwarded through the master. When the master fails, a new master is selected among backups to forward traffic. This implements gateway backup.

If load balancing is required in addition to gateway backup, configure two or more VRRP groups on an interface in multi-gateway load balancing mode.

Procedure

  • Create a VRRP group working in active/standby mode.

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

      NOTE:

      You are advised not to configure a VRRP group on the VLANIF interface corresponding to a super-VLAN. If VRRP groups are configured on the VLANIF interface corresponding to a super-VLAN, ensure that a maximum of 500 VLANs including common VLANs, super-VLANs, and sub-VLANs are used. Otherwise, device performance may be affected.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run vrrp vrid virtual-router-id virtual-ip virtual-address

      A VRRP group is created, and a virtual IP address is assigned to the VRRP group.

      By default, no VRRP group is created.

      NOTE:
      • Do not configure more than 1000 virtual IP addresses. Otherwise, the VRRP group will flap.

      • If many VRRP groups are configured, increase the CPCAR for VRRP Advertisement packets. Improper CPCAR settings will affect services on your network. If you need to adjust CPCAR settings, you are advised to contact Huawei technical personnel for help.

        You can also configure an mVRRP group and bind VRRP groups to the mVRRP group to prevent CPU resources consumed by protocol packets.
  • Create VRRP groups working in multi-gateway load balancing mode.

    If VRRP groups need to work in multi-gateway load balancing mode, repeat the steps to configure multiple VRRP groups on the interface and assign different VRIDs to them.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125445

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti