Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Summary of Smart Link and Monitor Link Configuration Tasks

Summary of Smart Link and Monitor Link Configuration Tasks

The switch supports the following Smart Link and Monitor Link features: basic functions of Smart Link, load balancing, link switching notification to the VPLS/VLL module, and basic functions of Monitor Link.

Table 6-2 describes the Smart Link and Monitor Link configuration tasks.

Table 6-2  Smart Link and Monitor Link configuration tasks

Scenario

Description

Task

Configure basic functions of Smart Link

Basic functions of Smart Link can be configured to implement active/standby link redundancy and switching, improving network reliability.

Configuring Basic Functions of Smart Link

Configure load balancing in a Smart Link group

Load balancing improves link efficiency.

Configuring Load Balancing in a Smart Link Group

Configure Smart Link to notify the VPLS/VLL module of link switching events

When Smart Link is used in VPLS or VLL networking, the link switching notification function enables the VPLS/VLL module to quickly detect link switching events, which minimizes data loss.

Configuring Smart Link to Notify the VPLS/VLL Module of Link Switching Events

Configure Monitor Link

Monitor Link monitors an uplink interface on a device and triggers Up/Down state transitions on downlink interfaces in accordance with state changes on the uplink interface. State transitions on the downlink interfaces then trigger link switching of the topology protocol on the downstream device.

Configuring the Uplink and Downlink Interfaces in a Monitor Link Group

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:124056

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti