Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
MAC Swap Loopback Features Supported by the Switch

MAC Swap Loopback Features Supported by the Switch

Local MAC Swap Loopback Test

A local MAC swap loopback test checks connectivity and performance of the network between a tester and a tested switch, as well as performance of the tested switch. In Figure 7-1, Ethernet frames sent by a tester traverse an Ethernet network and reach the tested switch (SwitchB). After the tested switch receives the Ethernet frames, it forwards them to the interface where local MAC swap loopback is configured. The tested switch swaps the source and destination MAC addresses of all Ethernet frames that match the local MAC swap loopback configuration and sends the Ethernet frames back to the tester through the interface where local MAC swap loopback is configured. The tester then analyzes network performance based on Ethernet frames sent from the tested switch.

When a local MAC swap test is performed on an interface, services on the interface are interrupted, but services on other interfaces are not affected. If a large number of test packets are sent, test packets occupy bandwidth of other services on the interface that sends test packets back to the tester.

Figure 7-1  Local MAC swap loopback test

Remote MAC Swap Loopback Test

A remote MAC swap loopback test checks connectivity and performance of the network between a tester and a tested switch but does not check performance of the tested switch. In Figure 7-2, Ethernet frames sent by a tester traverse an Ethernet network and reach the tested switch (SwitchB). After the tested switch receives the Ethernet frames, the switch swaps the source and destination MAC addresses of all Ethernet frames that match the remote MAC swap loopback configuration and sends the Ethernet frames back to the tester through the interface where remote MAC swap loopback is configured. The tester then analyzes network performance based on Ethernet frames sent from the tested switch.

A remote MAC swap loopback test modifies only Ethernet frames matching the MAC swap loopback configuration on an interface, and other Ethernet frames can still be forwarded on the interface. However, if a large number of test packets are sent, test packets occupy bandwidth of other services on the interface.

Figure 7-2  Remote MAC swap loopback test
Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:124164

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti