Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Why Does MAC Address Triggered ARP Entry Update Need to Be Configured When Devices of a VRRP Group Connect to Servers

Why Does MAC Address Triggered ARP Entry Update Need to Be Configured When Devices of a VRRP Group Connect to Servers

On the Ethernet, MAC address entries are used to guide Layer 2 data forwarding. The ARP entries that define the mapping between IP addresses and MAC addresses guide communication between devices on different network segments.

In a scenario where devices of a VRRP group connect to servers, the outbound interface in a MAC address entry is updated by packets, whereas that in an ARP entry is updated after the aging time is reached. In this case, the outbound interfaces in the MAC address entry and ARP entry may be different. To address this issue, run the mac-address update arp command to enable the MAC address triggered ARP entry update function. In Figure 3-27, SwitchA and SwitchB function as gateways of the server and have VRRP enabled to enhance reliability. VRRP packets are transmitted on the directly connected link between the two switches. When the server sends packets, only one network interface is selected to forward packets. When a network fault or traffic exception is detected, another network interface is used.

  • SwitchA functions as the master device and the server uses Port1 to send packets. SwitchA learns the ARP entry and MAC entry on Port1, and SwitchB learns the server MAC address on Port2.
  • When the server detects that Port1 is faulty, the server uses Port2 to forward service packets. SwitchA learns the server MAC address on Port2. If the server does not send an ARP Request packet to SwitchA, SwitchA still learns the ARP entry on Port1. In this case, packets sent from SwitchA to the server are forwarded through Port1 until the ARP entry is aged out.

To solve the problem, configure MAC address triggered ARP entry update. This function enables the device to update the corresponding ARP entry when the outbound interface in a MAC address entry changes.

Figure 3-27  Networking diagram for configuring MAC address triggered ARP entry update when a VRRP active/backup switchover is performed

MAC address triggered ARP entry update is disabled by default. To enable this function, run the mac-address update arp command.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125362

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti