Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Ethernet OAM 802.1ag MAC Trace Fails

Ethernet OAM 802.1ag MAC Trace Fails

Common Causes

This fault is commonly caused by one of the following:

  • The destination node is not configured with the MEP of the same level as the MEP on the source node.

  • The MEP level of the intermediate node is the same as or higher than the MEP level of the source node.

  • The intermediate node does not have a MAC address entry with the destination node.

NOTE:

Perform the following operations on the device where the fault occurs and on the downstream MEP or MIP of the device.

Procedure

  1. Run the display this command in the MD view on the source node and destination node to check whether MEP levels of the source node and destination node are the same.

    • If yes, go to step 2.

    • If not, delete the MD, run the cfm md command to create a new one, and set the MEP level of the destination node to be the same as that of the source node.

      • If the source node successfully traces the MAC address of the destination node based on 802.1ag, the fault has been rectified.

      • If the source node fails to trace the MAC address of the destination node based on 802.1ag, go to step 2.

  2. Run the display cfm mep command to check whether the MEP level of the intermediate node is the same as or higher than the MEP level of the source node.

    NOTE:

    802.1ag packets in low-level MDs cannot pass through high-level MDs, whereas 802.1ag packets in high-level MDs can pass through low-level MDs. 802.1ag packets with the same level of the MD cannot traverse the MDs.

    • If not, go to step 3.

    • If yes, delete the MD, run the cfm md command to create a new one, and change the MEP level on the intermediate node.

      • If the source node successfully traces the MAC address of the destination node based on 802.1ag, the fault has been rectified.

      • If the source node fails to trace the MAC address of the destination node based on 802.1ag, go to step 3.

  3. Run the display mac-address dynamic [ slot-id ] [ interface-type interface-number | vlan vlan-id ] command to check whether the intermediate node has a MAC address entry with the destination node.

    If not, run the ping mac-8021ag command to enable the intermediate node to learn the MAC address of the destination node.

    If the source node successfully traces the MAC address of the destination node based on 802.1ag, the fault has been rectified.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:124147

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti