Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Configuring Association Between VRRP and Routing to Monitor the Uplink Status

Configuring Association Between VRRP and Routing to Monitor the Uplink Status

Context

Because VRRP cannot detect faults on the uplink of a VRRP group, services may be interrupted. The VRRP group monitors the number of routes on the uplink forwarding path. When the route is withdrawn or becomes inactive, the master's priority is adjusted and an active/standby switchover is performed. This reduces the link fault on service forwarding.

When the fault is rectified, the original master restores its priority and switches to the master to forward traffic.

During route association, the link switchover depends on convergence of a routing protocol associated with the VRRP group.

NOTE:
  • When a VRRP group is associated with a static route, the device can detect only faults on the direct uplink.

  • The master and backup in the VRRP group must work in preemption mode. It is recommended that the preemption delay be 0 on the backup and non-0 on the master.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface on the master where a VRRP group is configured is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run vrrp vrid virtual-router-id track ip route ip-address { mask-address | mask-length } [ vpn-instance vpn-instance-name ] [ reduced value-reduced ]

    Association between a route and a VRRP group is configured.

    By default, the master's priority decreases by 10 if the associated route is withdrawn or becomes inactive.

    When setting the value by which the priority decreases, ensure that the priority of the backup is higher than the priority of the master.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125174

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti