Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
DLDP Authentication Modes

DLDP Authentication Modes

If a link of the DLDP interface is in Up state, the DLDP interface sends DLDPDUs to the remote device and processes the DLDPDUs received from the remote device. To ensure packet validity on an insecure network, users can configure one of the following authentication modes for DLDPDUs.

Table 5-3  Authentication modes of DLDPDUs

Authentication Mode

Description

Non-authentication mode

The sender sets the authentication key of the DLDPDUs to all 0s and the authentication type field to 0. The receiver compares the authentication key and authentication type with those set on the local end. If the settings on the two ends are different, the receiver discards the DLDPDUs.

Simple authentication mode

The sender sets the authentication key of the DLDPDUs to the plain-text password set on the local end and the authentication type field to 1. The receiver compares the authentication key and authentication type with those set on the local end. If the settings on the two ends are different, the receiver discards the DLDPDUs.

MD5 authentication mode

The sender sets the authentication key of the DLDPDUs to the summary of the cipher text obtained from the password set on the local end using the MD5 algorithm, and sets the authentication type field to 2. The receiver compares the authentication key and authentication type with the summary of the cipher text obtained on the local end using the MD5 algorithm. If the settings on the two ends are different, the receiver discards the DLDPDUs.

SHA authentication mode

The sender sets the authenticator field of the DLDPDUs to the digest of the cipher text obtained from the password set on the local end using the SHA256 algorithm, and sets the authentication type field to 3. The receiver compares the authenticator and authentication type with the digest of the cipher text obtained on the local end using the SHA256 algorithm. If the settings on the two ends are different, the receiver discards the DLDPDUs.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:123885

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti