Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
BFD for OSPF

BFD for OSPF

A link failure or topology change may lead to route recalculation. Therefore, the convergence time of routing protocols must be shortened as much as possible to improve network performance. A possible solution is to quickly detect link faults and immediately notify routing protocols of the faults.

BFD for OSPF associates a BFD session with OSPF. The BFD session quickly detects a link fault and notifies OSPF of the fault. OSPF quickly responds to the network topology change. Table 2-1 lists OSPF convergence time.

Table 2-1  OSPF convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Timeout of the OSPF Hello keepalive timer

At the second level

Bound

BFD session in Down state

At the millisecond level

Application

Figure 2-8  BFD for OSPF

In Figure 2-8, SwitchA establishes OSPF neighbor relationships with SwitchC and SwitchD. The outbound interface in the route from SwitchA to SwitchB is Interface 1. Packets from SwitchA traverse SwitchC, and then reach SwitchB. When the OSPF neighbor is in Full state, the system instructs BFD to create a BFD session.

If a fault occurs on the link between SwitchA and SwitchC, the BFD session detects the fault and notifies SwitchA. SwitchA processes the neighbor Down event and recalculates the route. Interface 2 then becomes the new outbound interface in the route. Packets from SwitchA traverse SwitchD, and then reach SwitchB.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:124561

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti