Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
BFD for PIM

BFD for PIM

If a designated router (DR) on the shared network segment becomes faulty, Protocol Independent Multicast (PIM) neighbor relationships time out. This triggers a new DR election among PIM neighbors, interrupting multicast data transmission. The interruption period, usually in seconds, is at least as long as the timeout interval of the neighbor relationship.

After detecting a fault on the peer, BFD immediately instructs the PIM module to trigger a new DR election without waiting for timeout of the neighbor relationship.

BFD for PIM can quickly detect faults on the Assert winner and is also applicable to Assert election on a shared network segment.

Table 2-4 lists the PIM convergence time.

Table 2-4  PIM convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Neighbor relationship timeout

Second-level

Bound

BFD session in Down state

Millisecond-level

Application

Figure 2-14  BFD for PIM

In Figure 2-14, on the shared network segment connected to user hosts, downstream interface Interface1 on SwitchC and downstream interface Interface2 on SwitchD establish a PIM BFD session and send BFD control packets to monitor the link status.

SwitchC functions as the DR and Interface1 is responsible for forwarding multicast data. If Interface1 becomes faulty, BFD fast notifies the RM of the session status and the RM notifies the PIM module. The PIM module then triggers a new DR election. SwitchD quickly begins functioning as the new DR and Interface2 begins forwarding multicast data to the receivers.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:124854

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti