Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Overview of Y.1731

Overview of Y.1731

Y.1731 is used to implement end-to-end connectivity detection, loopback detection, and link trace on Metro Ethernets (MEs). It also provides test diagnosis and performance monitoring functions such as frame loss measurement, frame delay measurement, frame jitter measurement, and throughput measurement.

Ethernet in the First Mile (EFM) and Connectivity Fault Management (CFM) are used to detect link faults for carriers. Y.1731, an enhancement of CFM, can be configured to monitor service performance.

Hierarchical Ethernet operation, administration and maintenance (OAM) needs to be provided based on the network architecture, as shown in Figure 10-1.

Figure 10-1  Ethernet OAM networking

Y.1731 is an OAM protocol defined by the Telecommunication Standardization Sector of the International Telecommunication Union (ITU-T). It covers items defined in IEEE 802.1ag and provides additional OAM messages for fault management and performance monitoring. Fault management includes alarm indication signal (AIS), remote defect indication (RDI), locked signal (LCK), test signal, automatic protection switching (APS), maintenance communication channel (MCC), experimental (EXP) OAM, and vendor specific (VSP) OAM. Performance monitoring includes frame loss measurement (LM) and delay measurement (DM).

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:123922

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti