Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
BFD for BGP

BFD for BGP

BGP enables the Switch to periodically send Keepalive packet to its peers for fault detection. Detecting a fault using this method takes more than 1 second. When traffic is transmitted at gigabit rates, second-level fault detection times cause significant packet loss. Association between BFD and the Border Gateway Protocol (BGP) enables BFD to quickly detect faults on links between BGP peers and report the faults to BGP, implementing fast BGP route convergence. Table 2-3 lists the BGP convergence time.

Table 2-3  BGP convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Keepalive packet mechanism

At the second level

Bound

BFD session in Down state

At the millisecond level

Application

Figure 2-10  BFD for BGP

In Figure 2-10, SwitchA belongs to AS 100, and SwitchB belongs to AS 200. SwitchA and SwitchB are directly connected and establish an External Border Gateway Protocol (EBGP) connection. BFD monitors the status of the EBGP connection between SwitchA and SwitchB. When the link between SwitchA and SwitchB becomes faulty, BFD can quickly detect the fault and notify BGP.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:124471

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti