Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Setting the Global TTL Value

Setting the Global TTL Value

Context

When devices running different versions interwork with each other, the TTL values and detection modes on both ends of the BFD session are different and BFD packets are discarded. You can set the global TTL value to enable the Huawei device to interwork with each other in different versions, with upgraded devices, and with non-Huawei devices.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally on the local node and the BFD view is displayed.

  3. Run peer-ip peer-ip mask-length ttl { single-hop | multi-hop } ttl-value

    The TTL value of BFD control packets is set.

    The TTL value of BFD packets varies with the BFD session type. By default, for a static BFD session, the TTL value of a single-hop BFD packet is 255 and the TTL value of a multi-hop BFD packet is 254. For a dynamic BFD session, the TTL value of a single-hop BFD packet is 255 and the TTL value of a multi-hop BFD packet is 253.

    NOTE:
    • After the TTL value in multi-hop BFD packets is configured, you must configure the same peer IP address, mask length longer than the mask length for the TTL value in multi-hop BFD packets, and TTL value in single-hop BFD packets. This is because the TTL value in multi-hop BFD packets affects dynamic single-hop BFD sessions.

    • If the MPU has the ES0D00FSUA00 card installed or the MPU is EH1D2SRUDC00/EH1D2SRUDC01, you must change the global TTL value on both ends of a BFD session in Up state. Otherwise, the BFD session cannot go Up again.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125094

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti