Nessuna risorsa pertinente trovata nella lingua selezionata.

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Configuring Smart Link to Notify the VPLS/VLL Module of Link Switching Events

Configuring Smart Link to Notify the VPLS/VLL Module of Link Switching Events

Pre-configuration Tasks

When Smart Link is used on a VPLS/VLL network, you can configure Smart Link to notify the VPLS/VLL module of link switching events so that the VPLS/VLL module can rapidly detect link switching events to minimize data packet loss.

Before configuring Smart Link to notify the VPLS/VLL module of link switching events, configure basic functions of Smart Link.

Context

In Figure 6-16, CE-A is dual-homed to the VPLS/VLL network through VLANIF interfaces or Dot1q termination sub-interfaces of the PEs. You can associate Smart Link with VPLS/VLL on the corresponding physical interfaces of PEs. The interfaces can then notify the VPLS/VLL module after receiving a Flush packet. After receiving the notification, the VPLS/VLL module clears the MAC addresses in the VSI/VLL bound to the VLANIF interface or sub-interface and sends messages to remote devices, prompting them to update MAC address entries.

NOTE:

You can associate Smart Link with VPLS/VLL only when CE-A is connected to the VPLS/VLL network through VLANIF interfaces or Dot1q sub-interfaces of the PEs.

Figure 6-16  Example of link switching notification to the VPLS/VLL module

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run smart-link { vpls-notify | vll-notify } enable

    The interface is enabled to notify the VPLS/VLL module after receiving a Flush packet.

    By default, an interface does not notify the VPLS/VLL module after receiving a Flush packet.

Verifying the Configuration

Run the display this command on a PE interface connected to CE-A to verify whether the interface is enabled to notify the VPLS/VLL module after receiving Flush packets.

Traduzione
Download
Updated: 2019-10-18

N. documento: EDOC1000178318

Visualizzazioni:125173

Download: 83

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti