Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
DLDP States

DLDP States

The Device Link Detection Protocol (DLDP) allows a device to identify the remote device and check connectivity of the unidirectional link by exchanging DLDP Data Units (DLDPDUs) with the remote device. DLDP defines the following states: Initial, Inactive, Active, Advertisement, Probe, Disable, and DelayDown.

Figure 5-3  State transition during DLDP packet exchange
Table 5-1  DLDP states

State

Description

Initial

DLDP is disabled.

Inactive

DLDP is enabled but the link is Down.

Active

DLDP is enabled and the link is Up, or neighbor entries are cleared.

Advertisement

All neighbors are bidirectionally reachable or have been in Active state for more than 5 seconds. This is a stable state when no unidirectional link has been detected.

Probe

Probe packets are sent to detect whether the link is unidirectional. When an interface enters this state, DLDP starts the probe timer and starts an echo timer for each neighbor to be detected.

Disable

DLDP in enhanced mode detects a unidirectional link and disables the interface that fails to send optical signals.

DelayDown

When an interface in Active, Advertisement, or Probe state receives a Port-Down event, the interface enters the DelayDown state but does not immediately delete neighbor entries and transitions to the Inactive state. In DelayDown state, the system reserves DLDP neighbor information and only responds to Port-Up events.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:124234

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti