Nessuna risorsa pertinente trovata nella lingua selezionata.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S7700 and S9700 V200R011C10

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei utilizza la traduzione automatica insieme alla revisione umana per tradurre questo documento in diverse lingue, per facilitare la comprensione del contenuto di questo documento. Nota: la traduzione automatica, anche la più avanzata, non può corrispondere alla qualità dei trasduttori professionisti. Huawei non accetta alcuna responsabilità per l'accuratezza della traduzione e raccomanda di fare riferimento al documento inglese (per il quale è stato fornito un collegamento).
Unidirectional Link Detection When Multiple Neighbors Exist

Unidirectional Link Detection When Multiple Neighbors Exist

DLDP can be configured for devices connected by hubs to detect unidirectional links. Each interface detects at least one neighbor.

As shown in Figure 5-7, a hub connects SwitchA to SwitchB, SwitchC, and SwitchD through copper twisted pairs or optical fibers. All switches support DLDP. To detect unidirectional links on this network, enable DLDP on all switch interfaces connected to the hub.

Figure 5-7  Networking diagram of multiple neighbors

On a network with multiple neighbors, an interface immediately enters the Disable state when receiving Disable packets from a neighbor or detecting that a neighbor is unidirectional. When SwitchA, SwitchB, and SwitchC detect a unidirectional link fault on SwitchD, they transition to the Disable state. This prevents traffic forwarding errors when the topology changes. If the Rx optical fiber between SwitchB and the hub is disconnected when SwitchA is forwarding traffic to SwitchB, SwitchA shuts down its interface connected to the hub and stops sending packets to SwitchB, SwitchC, and SwitchD. If a backup link exists between SwitchA and SwitchB, STP immediately starts the backup link when SwitchA shuts down the interface.

If the switches on the preceding network are connected by a device that has DLDP disabled but supports DLDPDU forwarding, DLDP still detects unidirectional links as if the network has multiple neighbors.

Traduzione
Download
Updated: 2019-09-23

N. documento: EDOC1000178318

Visualizzazioni:123943

Download: 81

Average rating:
This Document Applies to these Products
Documenti correlati
Related Version
Share
Precedente Avanti