OceanStor UltraPath for Linux V100R008C50 User Guide 05
This document explains how to install and configure the UltraPath software on a Linux operating system and describes commonly used commands, alarm handling, and troubleshooting.
UltraPath Configuration Process
Before installing and using the UltraPath, learn about the installation precautions and configuration process. This helps you correctly install, configure, and use the UltraPath.
Precautions
- The controller enclosure of the storage system must be equipped with Fibre Channel and iSCSI interface modules.
- The Fibre Channel host ports on the storage system must be correctly connected to the HBAs of the application server.
- UltraPath V100R008 supports common Fibre Channel networking mode and iSCSI networking mode.
Configuration Process
Key Step |
Reference Section |
Remarks |
---|---|---|
Prepare for installation. |
Before installing the UltraPath, you must check whether the storage system, application server, and HBAs meet the UltraPath installation requirements. |
|
Install and configure the UltraPath (boot from local). |
This step applies to the scenario where you install the UltraPath for the first time or upgrade the UltraPath in boot from local mode. |
|
Install and configure the UltraPath (boot from SAN). |
This step applies to the scenario where you install the UltraPath for the first time or upgrade the UltraPath in boot from SAN mode. |
|
Manage the UltraPath. |
Describes the commonly used command-line interface (CLI) management commands of the UltraPath. |