S12700 Series Agile Switches Interoperation Configuration Guide (V200)
This document provides typical configuration examples for interoperation between Huawei switches and mainstream IP phones, Cisco ISE authentication servers, Cisco ACS authentication servers, Aruba ClearPass authentication servers, Microsoft NLB servers, multi-NIC servers, and Cisco switches.
This document provides typical configuration examples for interoperation between Huawei switches and mainstream IP phones, Cisco ISE authentication servers, Cisco ACS authentication servers, Aruba ClearPass authentication servers, Microsoft NLB servers, multi-NIC servers, and Cisco switches.
Interoperation Guide for Huawei S Series Switches and Cisco ISE
- Configuring Cisco ISE to Authenticate Common Access Users and ACS to Authenticate Switch Administrators
- Configuring 802.1X Authentication for Wired Users on Cisco ISE
- Configuring MAC Address Authentication for Wired Users on Cisco ISE
- Delivering VLANs or ACLs to Successfully Authenticated Users on Cisco ISE
- Configuring Portal Authentication for Visitors on Cisco ISE (Based on the HTTPS Protocol)
- Configuring CWA Authentication (MAC Address Authentication-based Portal Authentication Page Push) for Visitors on Cisco ISE
- Configuring Authentication for Access Users and Posture Service on Cisco ISE
- Configuring Authentication for Access Users on Cisco ISE (BYOD Scenario)
- Configuring Authentication for Access Users on Cisco ISE (Single-Gateway Free Mobility Scenario)
- Configuring Authentication for Access Users on Cisco ISE (to Implement Multi-Gateway Free Mobility Through VXLAN Packets Carrying Security Group Information)
Document ID：EDOC1000114001
Views：204241
Downloads：1335
Average rating：4.0Points