CX320 Switch Module V100R001 Command Reference 14
snmp-agent trap enable
Function
The snmp-agent trap enable command enables the switch to send traps.
The undo snmp-agent trap enable command restores the default setting.
The default configuration of the snmp-agent trap enable command can be checked by the display snmp-agent trap all command.
Usage Guidelines
- To enable the trap function for all modules, run the snmp-agent trap enable command.
- To disable the trap function for all modules, run the snmp-agent trap disable command.
- To enable the trap function for a specified module, run the snmp-agent trap enable feature-name feature-name command.
- To disable the trap function for a specified module, run the undo snmp-agent trap enable feature-name feature-name command.
- To enable a specified trap for a specified module, run the snmp-agent trap enable feature-name feature-name trap-name trap-name command.
- To disable a specified trap for a specified module, run the undo snmp-agent trap enable feature-name feature-name trap-name trap-name command.
- To restore the default trap status of all modules, run the undo snmp-agent trap disable or undo snmp-agent trap enable command.
The snmp-agent trap enable command must be used together with the snmp-agent target-host inform command or snmp-agent target-host trap command.
To enable a device to send traps, you need to run at least the snmp-agent target-host inform command or snmp-agent target-host trap command on the device to specify the destination address of the traps.
Related Topics
Document ID：EDOC1000128405
Views：7711640
Downloads：2083
Average rating：4.75Points